In order to give you a better service Airbus uses cookies. By continuing to browse the site you are agreeing to our use of cookies I agree

Weight and Balance Training

Aircraft Abailability | Applicability: Mixed fleet

Airbus Aircraft Family: A300 A310 | A320 | A330 | A340 | A350 | A380

These courses are aiming to introduce the Airbus method to design the Weight and Balance operational documentation.

XG06 - Weight & Balance engineer course

Airbus Aircraft Applicability: A300 | A310 A320 | A330 | A340 | A350 | A380

Weight and Balance engineer course aims to introduce the Airbus method to design the weight and balance operational documentation (Balance chart, AHM560/565). The training also presents the Airbus aircraft weight limitations and the Center of Gravity limitation to check, to operate the aircraft.

This course, which is not ab-initio course but a “transition” course, aims at bringing to Weight and Balance engineers the knowledge of the aircraft systems and limitations, the knowledge of the operational documentation, the knowledge of the Weight and Balance calculation techniques, as well as the knowledge of the general Weight and Balance and regulation.

The course is designed for Weight and Balance Engineers or Performance Engineers familiar with Weight and balance calculations.

G07 / G17 - Load control transition course

Airbus Aircraft Applicability: A310A320 | A330 | A340 | A350 | A380

The aim of this course is to:

  • Present the different operational tools used for load control (paper Trim sheet, Load message, Loading Instruction Report, FlySmart+ Loadsheet application)
  • Familiarize trainees with the Airbus aircraft loading capability and specificities
  • Present the aircraft systems related to aircraft loading: fuel and cargo
  • Present the aircraft limitations considered to operate the aircraft

This course is not an ad-initio course but a “transition to Airbus” course.

The course is designed for qualified Load Controllers or Load Planners. 

Back to top